deltaserver403
Technical User
Hi ALL.
we are using 403 2.1 (27) with WAN3 Module.we 64 kbps frame rely link between 2 offices.
Ip address range is 172.16.15.1
gate way is 128.1.1.0
Ihave problem with avaya IPO get working.
I did the programming as follows.
1)Connected the WAN card to Controll unit & Rebooted the system, when i login to Mnager i can see the WAN card
2) when go to Control UNIT form i am unable to see the WAN card, I created the WAN card & Re Booted the System
3) It taken WAN 3 Ports WAN201,WAN202,WAN203
4) after this i created the service WAN Service, system automaticaly created the User & RAS .
5) in WAN service form i allocated the IP address 10.15.15.2(This address is serial link) S/N - 255.255.255.252.
6)I created the IP Route . 128.1.1.0 S/N 255.255.255.0 this remote end Lan IP
7)in WAN port 201 , i enabled the Sync Frame Rely,
Frame Relay Tab - selected the AnsiAnexD , Network , 1600
DLCi - 50 RFC1490+FRF12- RAS name filed i selcetd the services name - Capital.
after all this restord the programming to IPO Immidiatly, to rebbot.
But still i am unable to get in to onother network, i belive i am doing some mistak in the programming pls can anybody did this Frame relay link pls suggest me.
Thanks In advance
we are using 403 2.1 (27) with WAN3 Module.we 64 kbps frame rely link between 2 offices.
Ip address range is 172.16.15.1
gate way is 128.1.1.0
Ihave problem with avaya IPO get working.
I did the programming as follows.
1)Connected the WAN card to Controll unit & Rebooted the system, when i login to Mnager i can see the WAN card
2) when go to Control UNIT form i am unable to see the WAN card, I created the WAN card & Re Booted the System
3) It taken WAN 3 Ports WAN201,WAN202,WAN203
4) after this i created the service WAN Service, system automaticaly created the User & RAS .
5) in WAN service form i allocated the IP address 10.15.15.2(This address is serial link) S/N - 255.255.255.252.
6)I created the IP Route . 128.1.1.0 S/N 255.255.255.0 this remote end Lan IP
7)in WAN port 201 , i enabled the Sync Frame Rely,
Frame Relay Tab - selected the AnsiAnexD , Network , 1600
DLCi - 50 RFC1490+FRF12- RAS name filed i selcetd the services name - Capital.
after all this restord the programming to IPO Immidiatly, to rebbot.
But still i am unable to get in to onother network, i belive i am doing some mistak in the programming pls can anybody did this Frame relay link pls suggest me.
Thanks In advance