Help Installing Miran Card 2

[TD22]

I have an old Miran card with key codes and I want to intall
it in our opt 51. I have connected to the card with the maintenance cable and logged in via my laptop. The front LED display is "RAA0". The login screen shows I have a card version 1.56 Rls 09, the display also shows key codes validated. Once logged in via admin and pass admin000 the next screen shown is one titled "Pack Status". It shows Board Enabled: No and Channel 0,1,2,3 Unequipped. The cursor blinks and nothing seems to make it move. I am stumped on were to go from here. I have the manuals but they are geared for a new install. I have tried LD 32 and nothing happens. Any Ideas? Thanks

 

[johnpoole]

you'll need to build ran trunks on the ports, then record the msg..use the last port for management access.. do the recordings that associate the recordings with the trunks... i'll lok up the prompts when i get to work tomorrow...maybe this will get you started

john poole
bellsouth business
columbia,sc

 

[techman3030]

What you have done is gone down too far on the login sceen.
type in your pass and hit enter, then you should be on the log on button, just hit enter again and you will be in. status is the next selection below logon.

 

[TD22]

Thanks John, I did all the programming in LD 14,15,16 and 17 and now the card stat's like it should

Thanks Techman, Your instructions helped alot as I was able to determine I had an old card that worked on password 4321
and your tip helped me get the MOH going.

For my first ever post this worked great,thanks to you 2 and Tek-Tips.