Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

help in ld 14 on an opt 61 1

Status
Not open for further replies.

tmaxxpbxtek

Vendor
Feb 3, 2006
31
US
I am adding a new group of 24 and I am trying to copy the programming from the first group...This is what I have done so far.....
ld 20
prt
tnb
and found 26 24 to be teh last tn in that group

then to ld 14
req new 24
type did
tn this is where I am not sure what to put in ......this loop 27 that I am plugged into on the rear of an option 61
do I just put in 27 1 and it will go from there after I put in the rest of the info??? I remember putting in new 24 should just take it and build a copy of each one...am I correct or WAY OFF????

Just a squirrel trying to get a nut...

 
no your right, 24 1, then just each command to build one trunk, the rest go in sequential, without asking anymore questions.. very few things require a changem trunk type.. rtmb route and menber, if it's a new route.. 27 1.. if it's going to be an addition to a working route 1 49, would put it in route 1 as member 49

john poole
bellsouth business
columbia,sc
 
no your right, 24 1, then just each command to build one trunk, the rest go in sequential, without asking anymore questions.. very few things require a changem trunk type.. rtmb route and menber, if it's a new route.. 27 1.. if it's going to be an addition to a working route 26 25, would put it in route as the next trunk

john poole
bellsouth business
columbia,sc
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top