Help Getting MATWorX To Connect To 1000 IVS

[jdsanders]

All,

I'm having trouble getting MATWorX32 (v11.5.2) to connect to my NEAX 1000 IVS. This is my first time using MATWorX. I use the same PC to regularly connect to our AD8 VM. It is a generic 56K PCI modem.

I am using a modem dial string with pauses (and have the modem speaker turned on), so I am making it successfully through the auto-attendant and to the modem Ext. I can hear the modems shake hands and then connect (and the speaker goes off). I DO get a “Connected at 19200” message. After that, the connecting box just sits there for about half a minute and then closes and another window pops up and says “Can’t connect to PBX.”

The MATWorX manual says to force the connection to 2400 for an IVS 2000, but I don't see anywhere to change the baud in Matworx. I tried to do it via S registers in the init string, but it still connects @19200. Maybe I need a better init string?

Any help would be GREATLY appreciated.

 

[3racefan3]

WORX32 is not meant to work on the IVS product line, it can be used on the IVS2 and IPS systems.

 

[belevedere]

The IVS default baud rate is 1200. MatWorX will not connect to a speed that slow. Try changing the baud rate to 9600. CMD 4008 de 1 de 4 exe. You will not be able to use any of the GUI screens, but you may be able to use the MOC mode (command line) to program.

 

[OzzieGeorge]

It would be just as easy to use hyperterminal. See the FAQs for key definitions.