Error is:
%1 could not be found
Failed to open document
Am using CR 2008.
The error occurs regardless of whether I double-click on the *.rpt file or if I start CR then load the the *.RPT.
I was working on this file last week and have quite a bit of time invested in it.
It contains about 2 dozen sub-reports (I'm not the original author).
The original file, before the changes, works fine so it is probably not a data/connection issue.
The errors are not in any of the help/documentation.
Is anyone familiar with this error?
CR does not seem to have a menu option to repair corrupt RPT files, if that's what this is.
There does not seem to be a way to load this in a design/debug mode to find which subreport may be causing the problem.
Any help appreciated.
Thx.
%1 could not be found
Failed to open document
Am using CR 2008.
The error occurs regardless of whether I double-click on the *.rpt file or if I start CR then load the the *.RPT.
I was working on this file last week and have quite a bit of time invested in it.
It contains about 2 dozen sub-reports (I'm not the original author).
The original file, before the changes, works fine so it is probably not a data/connection issue.
The errors are not in any of the help/documentation.
Is anyone familiar with this error?
CR does not seem to have a menu option to repair corrupt RPT files, if that's what this is.
There does not seem to be a way to load this in a design/debug mode to find which subreport may be causing the problem.
Any help appreciated.
Thx.