Help about privilege levels (Cisco 2960)

[veilside]

Hi all,

I want to configure user privilege on CISCO 2960 Switch, with specified needs

user level 5 can do "Switch#show command" and all sub commands under show, and change interfaces modes, VLAN, shutdown, and no shutdown, except some interfaces like trunk interfaces. is it possible to be done ?

I have tried the following with no hope;

username test privilege 5 password 7 XXXXXXXXXXXXX
username admtest privilege 7 password 7 XXXXXXXXXXX

# privilege interface level 5 shut
# privilege interface level 5 no shutdown
# privilege interface level 5 switchport
# privilege interface level 5 switchport access vlan
# privilege interface level 5 switchport mode access
# privilege configure level 7 interface vlan
# privilege configure level 7 interface GigabitEthernet1/0/52
# privilege configure level 7 interface GigabitEthernet1/0/51
# privilege configure level 7 interface GigabitEthernet1/0/50
# privilege configure level 7 interface GigabitEthernet1/0/49
# privilege configure level 5 interface
# privilege exec level 5 configure terminal
# privilege exec level 5 write memory