Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

hello, I have installed a new an

Status
Not open for further replies.

6453

IS-IT--Management
May 10, 2003
52
US
hello,

I have installed a new analog DID card and 4 analog lines in a MICS with 6.0 and have done everything as instructed. in programming lines the lines are correctly identified as DID and I can change signaling but I can not find anywhere to enter rec'd number!!!

any help?

Thanks in advance.
 
You need to set up your target lines. We're used to the target lines starting at line 145, but I think in 6.0, they start at 157.

MarvO said it
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top