Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

heatsink installation 2

Status
Not open for further replies.

titokaro

Technical User
Jun 20, 2005
7
NZ
Ive just bought a Scythe Katana heatsink for my socket A processor , I note that the base of the heatsink because of its small size will only only just sit on the little rubber plugs on the top of the chip . The full weight of the heatsink will rest firmly on the die . Does any body have any suggestions for a firmer support, or at least avoid the potencial rocking motion on installation
cheers Tito

 
titokaro,

This HS when used for the AMD 462(Socket A) chip is noted to be a simple install, not requiring any special mounting hardware. It utilizes the standard single clip that provides the correct amount of pressure to secure the HS to the chip.

As this is not a HS that is overly heavy, the correct installation with the clip should be completely adequate for a sound installation.

You have probably noticed the caution on installation direction in the manual. But the link is a good reference if you have not:


Hope This Helps

rvnguy
"I know everything..I just can't remember it all
 
I know what you mean but i have always just gone ahead and carefully installed as is with no problems.
But there are spacers you can buy, around $7, that will fit in there and give more support. YOu can get them at newegg.com and a lot of other places.


Good advice + great people = tek-tips
 
Here's a shim for you for socket a, i couldnt find one at newegg.com.


rvnguy, i posted same time as you did. As you can see in my post i essentially agree with you.

On the other hand, they do make these shims, so ...


Good advice + great people = tek-tips
 
Thanks for the star, appreciate it.


Good advice + great people = tek-tips
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top