I´m installing Unixware 7.1.1 on a Intel SC7200CW2 server board with 1 XEON 2.0 Ghz processor. If installing from diskette #1, then diskette #2 is not recognized (but i know they´re OK because i tested them in an older machine).
If installing directly from CD# 1, HBA diskette is not recognized (at HBA insert time).. message appears in a red square: disk inserted is not HBA Type....... again, i tested the procedure in an older pc, and everything was OK.
(I have a DPT Raid controller , 3 SCSI HD 18.2Gb, configured in RAID 5, and i know that my DPT PM1564U3 is supported by UWare 7.1.1 via HBA disk supplied by SCO)
Any clues
Bergher
If installing directly from CD# 1, HBA diskette is not recognized (at HBA insert time).. message appears in a red square: disk inserted is not HBA Type....... again, i tested the procedure in an older pc, and everything was OK.
(I have a DPT Raid controller , 3 SCSI HD 18.2Gb, configured in RAID 5, and i know that my DPT PM1564U3 is supported by UWare 7.1.1 via HBA disk supplied by SCO)
Any clues
Bergher