Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
hard drive dont recive voltage 1
- Thread starter felixcain
- Start date
-
1
- #2
If voltages are at the AMP connector but the drive doesn't spin up there are 3 possibilities: 1) Logic board is not passing current through to the motor 2) The motor has gone defective 3) something is holding the platters from spinning.
Logic board swap is one step in diagnosis. But it is important that you use a board at the same ec (engineering change) level or you may have some problems with recovering data.
Ed Fair
Give the wrong symptoms, get the wrong solutions.
Logic board swap is one step in diagnosis. But it is important that you use a board at the same ec (engineering change) level or you may have some problems with recovering data.
Ed Fair
Give the wrong symptoms, get the wrong solutions.
- Status
Similar threads
