I am trying to setup a 120gb Maxtor HDD in my compaq server. However, the hard drive is only being detected as a 6gb! How do I resolve this problem, as I want to use the full capacity of the drive?
Suggest that the bios on the system be upgraded and then check the jumper settings on the HDD. sometimes when set to master, it may not do the trick. You may need to change it to cable select (CS) since this is a neutral setting for the drive.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.