Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

hacmp configuration question?

Status
Not open for further replies.

polani

Instructor
Jun 4, 2003
159
CA
Guys.

i do have a two nodes hacmp cluster with each nodes having only one logical ethernet interface ( etherchannel)

The same interface carry boot ip and service ip .

Now i want to configure netmon.cf file on both nodes and question is which ip address should i put in netmon.cf file?

Should i put any router or default gateway on service ip subnet ? But if i do so then that DG ip address would not ping from standby node as there are no persistent ip addresses? Will this config work?



Here comes polani Once again!!!



 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top