HACMP 5.3 IP replacement and HWAT

[MoreFeo]

Hi, I've been told to configure a 2 node cluster with IP replacement and HWAT.
I took the IBM HACMP course a long time ago, and don't remember anything, and the course book doesn't help a lot about configuring IP replacement and HWAT.
I've searched in the redbooks area, but haven't found a good tutorial or example. Does anyone know the steps I need to follow, or a link to a good book?

The cluster configuration is like this:
2 nodes
2 ethernet adapters in each node
3 ip addresses in each node: boot, service and stand-by
heartbeating over disk

I've created the /etc/hosts file, and the enhanced VG.
I've created the cluster (by adding nodes in the standard configuration)
I've set the network not to use IP Aliases.
I've configured the non IP network on hdisk.
I've created the service IP label.
I've created the resource group, and updated it with the service IP label and the VG.
At this point, when I try to verify the cluster it fails, so I know I'm missing something, but I don't know where, so I'd apreciate any help.

Thanks

 

[rswider]

You could check the log files from /var/hacmp/clverify/ to obtain more information.
Radu