H323 GW and dial-peers

[iptuser]

I always thought that with a MGCP GW the incoming and outgoing dial-peers are pots and with incoming pots you add ISDN BIND-L3 CCM MANAGER to tie it back to CUCM and with H323 GW`s the outgoing from CUCM is POT`s to the Telco and the incoming from Telco to CUCM is voip though you may have a dial-peer voice 9 pots with answer-called . , direct dial inward etc to answer, anchor the call.. However someone else suggested that with H323 it can also be POTS in both directions- is this correct? In the H323 GW configuration in CUCM you do not configure a VWIC as in mgcp but just create a H323 GW- the CUCM has no knowledge of the number of circuits the GW has unlike MGCP. Can someone confirm

thanks

 

[whykap]

in h323 cucm has no knowledge or control over the gateway.
In mgcp mode cucm has complete control of the voice functions of the gateway. master/slave relation

in h323 cucm just passes and receives calls from the gateway and the gateway controls all voice circuits configured. it is peer to peer relation.