H.323 trunk - two Avaya's - assistance

[ktripp]

I'm building a H323 trunk between two Avaya's. One is 5.1 - S8510 with g650 cabinets, clan's and medpro and the other is a S8300D in a G450.

I've set these up before and had never had this much trouble. I was hoping it was something simple that someone can point out. The sig groups are mirrored as well as the trunk groups. The trunk groups never come up - always stating 'out-of-service-NE'.

here is the config of side one - again mirrored on the other unit.
change signaling-group 10 Page 1 of 6
SIGNALING GROUP

Group Number: 10 Group Type: h.323
Remote Office? n Max number of NCA TSC: 0
SBS? n Max number of CA TSC: 0
IP Video? n Trunk Group for NCA TSC:
Trunk Group for Channel Selection: 10
TSC Supplementary Service Protocol: a
T303 Timer(sec): 10
H.245 DTMF Signal Tone Duration(msec):
Near-end Node Name: procr Far-end Node Name: procr-shenzhen
Near-end Listen Port: 1720 Far-end Listen Port: 1720
Far-end Network Region: 101
LRQ Required? n Calls Share IP Signaling Connection? n
RRQ Required? n
Bypass If IP Threshold Exceeded? n
H.235 Annex H Required? n
DTMF over IP: out-of-band Direct IP-IP Audio Connections? y
Link Loss Delay Timer(sec): 90 IP Audio Hairpinning? n
Enable Layer 3 Test? n Interworking Message: PROGress
H.323 Station Outgoing Direct Media? n DCP/Analog Bearer Capability: 3.1kHz

change trunk-group 10 Page 1 of 21
TRUNK GROUP

Group Number: 10 Group Type: isdn CDR Reports: y
Group Name: OUTSIDE CALL COR: 1 TN: 1 TAC: 816
Direction: two-way Outgoing Display? n Carrier Medium: H.323
Dial Access? n Busy Threshold: 255 Night Service:
Queue Length: 0
Service Type: tie Auth Code? n
Member Assignment Method: manual
Remaining pages are defaults except for a single trunk member.

In the sig groups, I have tried different combinations of nodes. In the S8510 I have used the main IP as well as clan boards.
In the G450 there is only one ip for the processor, and one for the G450 chassis. Been using the processor ip in the sig group.

Both are licensed for h323 trunks

I've scoured this forum. I've even tried to create a SIP sig group and SIP trunk and still cannot get the trunk to come up.
I have ip communicatoins between each pbx (ping).

Any suggestions? This has got to be a simple one..something I am overlooking...I hope.

Thanks,

 

[leftyx]

In the Node-name field you have "procr" and "procr-shenzhen"...are those the CLAN's of the two systems? I only ask cause it seems to be an abbreviation of "Processor".

 

[ktripp]

Thanks for the response. the node names are the ip's of the applicable devices. I finally did get it working realizing that I did not have a tie from the network region back to region 1. I belive that was my issue. Trunk is up and running now.