h.323 Trunk between MXONE TSW and Alcatel pbx.

[enktr]

Hi,
My problem is h.323 Ip Trunk between MXONE TSW and Alcatel 4400 pbx.
We tried some test on h.323 trunk
- An Alcatel Extension calls to our MX-ONE TSW Extension : there is no problem for this call
- A MX-ONE Extension calls to Alcatel Extension : the call is starting without any problem, but call dropped in 30 seconds.

VERSION: CXP1010101/4/TSWSP07/SP07

RINIP:LIM=1;
IP NETWORK INTERFACE DATA
BPOS GRP IP ADDRESS MASK ROUTER ETHCNF VLAN SILDET
1-0-20 1 194.27.53.250 255.255.255.0 194.27.53.1 0 H'FFFF 1

END

RIANP:GRP=1;
H.323 ROUTE DATA
ROU GRP IP ADDRESS LROUID RROUID CODECS
89 1 BC4012356789A

END
RODDPEST=21;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST ADC TRC SRT NUMACK PRE
21 89 160610000000025000600000000 0 1 0
END

RODDPEST=21,IPOPT=YES;
EXTERNAL DESTINATION ROUTE DATA
DEST DRN ROU CHO CUST IP ADDRESS RROUID
21 89 194.27.65.254
END

ROCAP:ROU=89;
ROUTE CATEGORY DATA
ROU SEL TRM SERV NODG DIST DISL TRAF SIG BCAP
89 0110000000000010 5 3100000007 0 30 128 00151515 311110100091 111111
END

RODAP:ROU=89;
ROUTE DATA
ROU TYPE VARC VARI VARO FILTER
89 TL65 H'00000111 H'00000011 H'00000001 NO
END

ROEDP:ROU=89,TRU=ALL;
ROUTE EQUIPMENT DATA
ROU TRU EQU IP ADDRESS SQU INDDAT CNTRL
89 001-1
89 001-2
89 001-3
89 001-4
89 001-5
89 001-6
89 001-7
89 001-8


Thanks and regards
SKO

 

[nerdherder27]

I had the same problems with a trunk h323 with a ciscco CUCM and I solved it by changing:

last digit sig=0

and remember that the packetization is a 30 is you can not change.

 

[moustafa1234]

try to set the codecs for its default value 0-1-2-3-4-5-6-7-8-9-A-B-C.

and also last dig in signalling in the route category is set to 0