Hi all,
I have SES 5.2.1 installed and configured, connected to CM 5.2.1. The SES is talking to the CM, and the SIP trunk is up and in-service.
All checks and systems are ok. No alarms.
I have 2 x 4602SW phones with SIP software configured AND registered to the SIP server. I also have a 9630 configured as SIP and registered.
I have configured the off-pbx extensions etc etc ...
I CANNOT MAKE ANY CALLS!!
I cannot dial between the SIP endpoints (ext 3090, 3091 and 3092).
I cannot dial to or from the PABX.
If a trace a normal IP phone, it takes trunk 4 (SIP Trunk), but I just get engaged tone ...
ANY HELP PLEASE!! I have configured everything I can find in the documentation to configure - no luck.
Thank you in advance!
I have SES 5.2.1 installed and configured, connected to CM 5.2.1. The SES is talking to the CM, and the SIP trunk is up and in-service.
All checks and systems are ok. No alarms.
I have 2 x 4602SW phones with SIP software configured AND registered to the SIP server. I also have a 9630 configured as SIP and registered.
I have configured the off-pbx extensions etc etc ...
I CANNOT MAKE ANY CALLS!!
I cannot dial between the SIP endpoints (ext 3090, 3091 and 3092).
I cannot dial to or from the PABX.
If a trace a normal IP phone, it takes trunk 4 (SIP Trunk), but I just get engaged tone ...
ANY HELP PLEASE!! I have configured everything I can find in the documentation to configure - no luck.
Thank you in advance!