Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
getting message "too may files are open"
- Thread starter letu27
- Start date
Hi. Take a look at
It references adding files=X to the correct config file. It should solve your problem.
ChaZ
There Are 10 Types Of People In The world:
Those That Understand BINARY And Those That Don’t.
It references adding files=X to the correct config file. It should solve your problem.
ChaZ
There Are 10 Types Of People In The world:
Those That Understand BINARY And Those That Don’t.
- Thread starter
- #3
Thank you ChaZ for your interest in my problem. However, as usual, going to Microsoft for information is the most fruitless enterprise I have ever indulged in, as it was again this time. However, the solution to this problem became apparent to me when you mentioned CONFIG FILE. I went there and found that someone?sometime? had added a character(0) to the files = 20 statement. I deleted that character and now my program works again. Thank you so much for your help!
letu27
letu27
- Status
Similar threads
