Hello,
I'm modifying the Great Plains Dyanmics (General Ledger) Trial Balance Detail report in V10. I will be sorting it by segment 2, and along with the normal account totals I see, I'd also like to add an additional grouping by segment 2 with the totals of that group.
I found knowledge base article 871644 which addresses this perfectly, but at the end it tells me to load up the GLTB Sort Chunk file available with techknowledge article 8380.
Unfortunately, both article 871644 and 8381 only indicate they're good through version 7.5
The problem is that when I follow all the steps in the article, I get the message "Bad break field in an additional footer or header. Recheck.". I've done some troubleshooting with this error, but I haven't been able to solve the problem.
This seems like far too simple a problem to not have a solution. Any ideas?
Thank you,
LMos
I'm modifying the Great Plains Dyanmics (General Ledger) Trial Balance Detail report in V10. I will be sorting it by segment 2, and along with the normal account totals I see, I'd also like to add an additional grouping by segment 2 with the totals of that group.
I found knowledge base article 871644 which addresses this perfectly, but at the end it tells me to load up the GLTB Sort Chunk file available with techknowledge article 8380.
Unfortunately, both article 871644 and 8381 only indicate they're good through version 7.5
The problem is that when I follow all the steps in the article, I get the message "Bad break field in an additional footer or header. Recheck.". I've done some troubleshooting with this error, but I haven't been able to solve the problem.
This seems like far too simple a problem to not have a solution. Any ideas?
Thank you,
LMos