GDC-345H regestiration on LDK 300

[fares78]

Dear Support

I have LDK 300 System and i have added a WTIB card and connect one base station GDC-330B.
Im trying to register one dectphone GDC345H Folowing the procedure:

1- From the ipldk terminal : Trans/prog +0 +# + flex 1 + enter station number (112) +type ( 3) + Hold/Save.
it showing subscrebtion for some times the failed.

2- From the wirless terminal : up/down menue +51+ park number ( 091423)+ redail + AC CODE ( 12345678) +redail+ enter FT number (1) +press ok.

it showing subscreption then failed also.

Im not sure if i miss some thinge. Please advise .

Regards

Fares

 

[doktor]

2.
You can install one LG GDC 345H by following this procedure:
From the operator console (LKD-30):
* Press Trans/PGM + 0 + # + flex button 1 + desired station number of the DECT phone (e.eg. 112) + 3 (this means LG DECT phone GDC-345) + HOLD button.

Same as you wrote:
Trans/prog +0 +# + flex 1 + enter station number (112) +type ( 3) + Hold/Save.


You do not need to enter the PARK code when registreing the DECT phone.

Let me know if you have any problems with this.



///doktor

 

[fares78]

Dear Doktor

Thanks for your response.

It is working fine now ...the problem that the park code programmed is different than the park code written on the MPB Board.

So i tried Trans/Pgm + 0+# + flex butten 6 + change the park code + save.

You are right ,we dont need the park code when i register the wirless,i just press redail and it will start to search the signal.

it is ok now.

Thanks alot .

Regards

Fares

 

[doktor]

Nice to know thank you.

Here is how to register a WTIB board:

Registering of WTIB - board (only done once):
From attendant console (e.g. LKD30DS):
1. TRANS/PROG + 0 # + Flex BTN 6 + enter PARK (see PARK label on MPB (processor board) + HOLD/Save.
The PARK-code is a 14 digit code - and it always begins with 3110…… (All digits need to be entered!!)

2. Trans/PROG + 0 # + Flex BTN 3 + 1234 (example on: AC code) + HOLD/Save.

Now we are ready to register the DECT handets...

///doktor

 

[doktor]

Here is how to register DECT handset, GDC-345H:

Auto mode:

 (for menu (arrow up/down))
5 (for System)
1 (for Register)
REDIAL (Button with 2 circles, one pink and one grey) DO NOT enter the PARK code.
’SEARCHING’ is shown in the display
AC code (e.g. enter 1234 - must correspond with the WTIB settings!!)
REDIAL (Button with 2 circles, one pink and one grey) Press this button to accept the AC code.
BASE for Base 1 to 4. Enter 1, 2, 3 or 4 for actual system number (Use 1 if only one ipLDK system. (Base = system no.)
OK (Press the OK button)
’SUBSCRIBING’ is shown in the display.

IF OK the the extension number is shown in the display.
IF NOK then SUBS FAIL is shown in the display.


///doktor