I am setting up a demo unit of the BCM50 and a GATM4 so we can demo 7 analog trunks for some potential clients. I had a RJ21 Telephony cable special ordered to interface with the GATM4 and our telco block but can only get 2 of the lines to give dial tone on the BCM50. I am using the blue, green, orange and brown pairs from the 50 pin cable. Does anyone know if those are the correct pairs to use? The 2 pairs that I know work are blue and orange(lines 65 & 66). Lines 67 & 68 appear but as I said no dial tone. Thanks for the help.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations sizbut on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
GATM4 Wiring
- Thread starter tjcbs
- Start date
option11newby
Technical User
- Feb 18, 2004
- 524
Wire 2 miss 2 wire 2 miss 2 etc
white/blue connect
white/orange connect
white/green miss
white/brown miss
white/slate connect
red/blue connect
etc, etc
NCSS, NCDS, NCTS
white/blue connect
white/orange connect
white/green miss
white/brown miss
white/slate connect
red/blue connect
etc, etc
NCSS, NCDS, NCTS
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question