Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

GATM4 no dialtone

Status
Not open for further replies.

nvwgators

Programmer
Aug 23, 2010
15
US
I have a BCM400 with PRI added gatm4 but it shows up as line 181 - 184 but i cannot get a dialtone. From what i have read it says that it needs to be lines 65-68. But they are assigned in the system under the PRI.
My dip switch setting are 111110 bus 3 because 2 and 7 are already taken up.
 
The line number will depend on which bus you are using.
If the card is seen in the system it will tell you what line it's using.
Assign thes lines to your appearance buttons on the phone.
Connect your lines and make sure the card has been enabled.
 
Maybe I am way off on this but it does not see the phone so the set is inactive. I cannot assign the appearance button to the phone.
 
Not sure I understand IT DON"T SEE THE PHONE, i thought you were trying to add CO Lines to the system.
 
I am trying to add the GATM4 to my existing BCM400 phones system which has a PRI.
 
Yes but the GATM4 is for lines not phones. Are you saying that after you add the GATM4 the phones on the system wont come up?
 
I am not getting a dialtone on the analog phones off of the GATM4.
 
It's not for phones it is for CO Lines
 
For Analog phones you want an ASM (analog station mod)
 
Thanks for your help. I will get the correct part.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top