Do any of you chaps in the UK have any info on setting up Gamma IPDC sip trunks on the IP Office.
I have the following info from Gamma, but could do with pointing in the right direction as to how to configure the sip trunks on the IPO.
"Your IP Direct Connect Order, Gamma Order number 131119 has now been provisioned, and is ready for Acceptance Testing.
The details of your provisioned order are as follows:
IP Direct Connect Endpoint: DC2N00KKK023 - 81.131.21.171
The unique network identifier of the CPE that is connected to the IP Direct Connect Service)
Number of Channels: 2
Allocated DDI Number(s): 01618700000 - 01618700004
Configuration Details
Gamma Telecom IPDC SIP signalling gateway address: 83.245.6.81
1. Please note that the IPDC authentication is based on the CPE’s IP Address, hence the solution does not require SIP Trunk or Username/Password authentication.
2. The SIP header requirements in the INVITE packets originated from the CPE should be set as follows:
- SDP payload must be present, and must contain your public IP address
- FROM: header must contain public facing interface and originating CLI without leading zero
From: <sip:1234567890@public_ipaddress>
- TO: header must contain IPDC SIP gateway address and the called number with leading zero (UK number) or 00 (International number)
To: <sip:07891234567@83.245.6.81>
3. CLI numbers are validated against the Gamma assigned geo number ranges for each endpoint.
4. Traffic on the following ports must be forwarded through relevant routers and firewalls on the customer premises to allow access to the Gamma IP Direct Connect Network:
- TCP and UDP Port 5060 egress/ingress to 83.245.6.81 (IPDC SIP signalling gateway),
- UDP all ports between 6000 - 40000 egress/ingress to 83.245.6.82 (IPDC Media gateway) Omission of this setting will result in one-way speech!
(Please note if you require to port numbers to the IP Direct Connect endpoint, this process can only commence once the new IP Direct Connect node has successfully been provisioned and tested)
The Endpoint is now in a position to be tested, can you please undertake the pre-defined Service Acceptance Tests that were outlined in the e-mail that Gamma forwarded to you on Order Acceptance. (The tests are included in an attachment to this mail for your information)
I have the following info from Gamma, but could do with pointing in the right direction as to how to configure the sip trunks on the IPO.
"Your IP Direct Connect Order, Gamma Order number 131119 has now been provisioned, and is ready for Acceptance Testing.
The details of your provisioned order are as follows:
IP Direct Connect Endpoint: DC2N00KKK023 - 81.131.21.171
The unique network identifier of the CPE that is connected to the IP Direct Connect Service)
Number of Channels: 2
Allocated DDI Number(s): 01618700000 - 01618700004
Configuration Details
Gamma Telecom IPDC SIP signalling gateway address: 83.245.6.81
1. Please note that the IPDC authentication is based on the CPE’s IP Address, hence the solution does not require SIP Trunk or Username/Password authentication.
2. The SIP header requirements in the INVITE packets originated from the CPE should be set as follows:
- SDP payload must be present, and must contain your public IP address
- FROM: header must contain public facing interface and originating CLI without leading zero
From: <sip:1234567890@public_ipaddress>
- TO: header must contain IPDC SIP gateway address and the called number with leading zero (UK number) or 00 (International number)
To: <sip:07891234567@83.245.6.81>
3. CLI numbers are validated against the Gamma assigned geo number ranges for each endpoint.
4. Traffic on the following ports must be forwarded through relevant routers and firewalls on the customer premises to allow access to the Gamma IP Direct Connect Network:
- TCP and UDP Port 5060 egress/ingress to 83.245.6.81 (IPDC SIP signalling gateway),
- UDP all ports between 6000 - 40000 egress/ingress to 83.245.6.82 (IPDC Media gateway) Omission of this setting will result in one-way speech!
(Please note if you require to port numbers to the IP Direct Connect endpoint, this process can only commence once the new IP Direct Connect node has successfully been provisioned and tested)
The Endpoint is now in a position to be tested, can you please undertake the pre-defined Service Acceptance Tests that were outlined in the e-mail that Gamma forwarded to you on Order Acceptance. (The tests are included in an attachment to this mail for your information)