G450 Clocking 1

[trilogy8]

I've got new replacement G450 MG's online and registered, with the idea of retiring my G650's shortly. I'm moving services over slowly and the sync source came to mind. There's no s8300 in these as they will just be controlled by duplex and/or an ESS. Do I need to set the sync source for 1 of the DS1 boards? Wasn't sure if that's a carrier requirement or should be mandatory setup in the MG.

 

[kyle555]

yeah, the MG cli. With one PRI, you'd set it as primary, and allow failover to the free run/on the MG itself AND enable failback to the PRI when it comes back.

I refer to Mr Avaya Tier 3's wonderful step-by-step here:

http://www.iaug.org/p/fo/et/thread=35145

 

[AvayaTier3]

cm6 with g430 and g450 have new commands that allow making these changes from CM so you do not
have to use media-gateway CLI

change synchronization media-gateway
list synchronization media-gateway

list configuration ds1

                       SYSTEM CONFIGURATION - DS1 Circuit Packs

Location   Code    Vintage     Signaling         Name              CSU MOD

001V1      MM710BP HW16 FW051  isdn-pri          PRI1              n/a
002V1      MM710BP HW16 FW051  isdn-pri          PRI2              n/a

--------------------------------------------------------------------------------
list synchronization media-gateway

              SYNCHRONIZATION MEDIA-GATEWAY PLAN

       No.     Primary         Secondary

       1       001V1
       2       002V1

A great teacher, does not provide answers, but methods to teach others "How and where to find the answers"

bsh

40 years Bell, AT&T, Lucent, Avaya
Tier 3 for 30 years and counting
[URL unfurl="true"]http://bshtele.com[/url]