Hi,
Does anybody know what the command is on the FWSM context to see hits on a specific rule in an ACL. Usually on PIX/ASA I enter the following:
show access-list acl_name | inc line x permit
This command is accepted by the IOS but yields no information. I end up having to perform just a show access-list acl_name which leaves my screen scrolling for ages as I heavily use object-groups, all just to see one line which is typically a new line and as such is at the end. I would place new rules at the top if I thought it would help but you cannot cancel out of a command in firewalls until the command has run to completion(as you know) so it makes no difference, I still have to wait until every ACE hit is shown. The FWSM's are running FWSM Version 2.3(5) code.
Any help greatly appreciated.
Does anybody know what the command is on the FWSM context to see hits on a specific rule in an ACL. Usually on PIX/ASA I enter the following:
show access-list acl_name | inc line x permit
This command is accepted by the IOS but yields no information. I end up having to perform just a show access-list acl_name which leaves my screen scrolling for ages as I heavily use object-groups, all just to see one line which is typically a new line and as such is at the end. I would place new rules at the top if I thought it would help but you cannot cancel out of a command in firewalls until the command has run to completion(as you know) so it makes no difference, I still have to wait until every ACE hit is shown. The FWSM's are running FWSM Version 2.3(5) code.
Any help greatly appreciated.