I have put in an old Telecom 9600 to get a client out of trouble until he completes his development. Programmed up OK but not getting anything from the SMDR. System has PSTN lines. Does it need exchange pulses in order to for the SMDR to operate?
If so is it 12Khz or 50Hz.
Does any body make a pulse inserter so I don't need to get it fromthe excahnge.
We have MPi at the other end but without raw data it is useless.
Not getting a thing out of the port but can configure it as programming port and it works.
Thanks
South Coast
If so is it 12Khz or 50Hz.
Does any body make a pulse inserter so I don't need to get it fromthe excahnge.
We have MPi at the other end but without raw data it is useless.
Not getting a thing out of the port but can configure it as programming port and it works.
Thanks
South Coast