Hi all,
I need a bit of help trying to get my head around this issue. Just a simple hub and spoke topology with 4 routers, r4 hub and r1,2,3 spokes all fully mesh at layer 2 using main int only. sh frame pvc | = will bing all the pvcs up active, if I enable frame on interfaces I am able to ping all routers, however if I disable inverse arp and create static maps using the dlci from previous dynamic mapping all comes up good except one of the spoke routers, I can see lmi increasing and I am confident that l2 is fine, however the mapping to l3 fails. Any suggestions or additional reading material will be appreciated. Sorry I don't have access to the configurations.
Thank you.
I need a bit of help trying to get my head around this issue. Just a simple hub and spoke topology with 4 routers, r4 hub and r1,2,3 spokes all fully mesh at layer 2 using main int only. sh frame pvc | = will bing all the pvcs up active, if I enable frame on interfaces I am able to ping all routers, however if I disable inverse arp and create static maps using the dlci from previous dynamic mapping all comes up good except one of the spoke routers, I can see lmi increasing and I am confident that l2 is fine, however the mapping to l3 fails. Any suggestions or additional reading material will be appreciated. Sorry I don't have access to the configurations.
Thank you.