Hello all, I have had a frame relay config working but have had to erase the config and start again. I have a problem that I can ping the remote route through the FR Switch, but I am unable to ping my local serial interface. I also have a static route configured and also have the same problem with this. I have ran debug ip packet and it is erroring about
encapsulation failed. Is there a command that I need to add since I erased my old config? All frame relay commands so that all is ok. i.e show frame map and pvc etc.
Many thanks in advance..
encapsulation failed. Is there a command that I need to add since I erased my old config? All frame relay commands so that all is ok. i.e show frame map and pvc etc.
Many thanks in advance..