Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Foxpro 2.6 reporting under Windows 98
- Thread starter pdrakos
- Start date
A number of things to try:-
1. Since it works OK thru DOS but not Windows, ensure within the properties tab of the Icon used to start the application that all Memory settings are set to Auto.
2. When installing the printer, there is usually a default which allows you to print from MS-DOS based applicatons. Did you set this to 'Yes'. The default is normally 'No'.
3. Within your code, prior to starting each new print job, issue the command _PDSETUP = "" to clear any possible printer codes from the last job.
Keep in Touch.
1. Since it works OK thru DOS but not Windows, ensure within the properties tab of the Icon used to start the application that all Memory settings are set to Auto.
2. When installing the printer, there is usually a default which allows you to print from MS-DOS based applicatons. Did you set this to 'Yes'. The default is normally 'No'.
3. Within your code, prior to starting each new print job, issue the command _PDSETUP = "" to clear any possible printer codes from the last job.
Keep in Touch.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
