Forwarding 2250 Console for brief breaks

[TelecAdmin]

Hello all,

I have gone through the past posts and can't seem to find the exact solution to forwarding our receptionist's console to an alternate extension for short breaks. I see in the manuals that LD 15 - as indicated in a past forum post- is used to set up a second Night Service. This would be a second(the first is our after-hours recording)night service that would be, of course, used occasionally during the day to forward the receptionist to a 5500 extension. How do I go about putting a range of hours - 7AM-5PM - for the NIT2 with the TIM2? Is there more to it than this? I'm a bit wary of experimenting with these settings so I'm asking beforehand.
Thanks in advance!

 

[cmawbey]

print the NIT data in LD21

req prt
type nit
cust x

change in LD 15

REQ: CHG Change existing data block
TYPE: NIT Night Service
CUST xx Customer number
NIT1 x...x First Night Service DN by Time of Day
TIM1 hh mm Hour and Minute for First Night Service DN
NIT2 x...x Second Night Service DN by Time of Day
TIM2 hh mm Hour and Minute for Second Night Service DN
NIT3 x...x Third Night Service DN by Time of Day
TIM3 hh mm Hour and Minute for Third Night Service DN
NIT4 x...x Fourth Night Service DN by Time of Day
TIM4 hh mm Hour and Minute for Fourth Night Service DN
RPNS (NO) YES Recall With Priority During Night Service
ENS (NO) YES Enhanced Night Service enabled
- NWT (NO) YES Night Call Waiting Tone enabled
- NNT 0-253 Night Number Table
- NSO (NO) YES Enhanced Night Service enabled

TIM1 hh mm Hour and Minute for First Night Service DN. basic-12
Enter the hour and minute for First Night Service DN.
Where: hh = 0-23, mm = 0-59
Enter X to remove the time. TIM1 should be set earlier
than TIM2, 3 and 4. If no time is entered here, the
system assumes a 24-hour clock.
TIM2 hh mm Time for Second Night Service DN basic-12
TIM3 hh mm Time for Third Night Service DN basic-12
TIM4 hh mm Hour and Minute for Fourth Night Service DN
For all of the entries in the Night Service Time of Day
(NSTOD) feature, entering X for the DN deletes the
existing value for that entry. Entering <cr> allows the
user to select an existing entry, or skip to another
entry.