form truncated in design mode

[mark1110]

Hi,

I inherited a VFP6 program. When I go into design mode the form is truncated on the right side. I tried using the _screen command with no luck. How can I get the form to display correctly?

Thanks,

Mark

 

[JRB-Bldr]

Have you looked at your VFP6 Options (Tools - Options - Forms) for the setting of the Maximum Design Area?

It is possible that the setting is smaller than the size of the Form you are attempting to Modify.

Good Luck,
JRB-Bldr

 

[Olaf Doschke]

In the menu Tools->Options on the Form tab, check if you have set the maximum design area to something smaller than the form of the VFP6 project.

Bye, Olaf.

 

[mark1110]

That was it, thanks

Mark