Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Fluke MS2-TTK MicroScanner2 Network Cable Tester Kit ,,,Probe "Cable Map" issue

Status
Not open for further replies.
avenel

avenel

Vendor
May 17, 2006
5
AU
Dear Expert

I bought my Fluke MS2-TTK MicroScanner2 Network Cable Tester Kit from ebay on November 2017 and it is brand new.

Today I was trying to use “Wire Map” mode that is located on its probe and the LED light supposed to be jumping between number 1 to 8 as per below :

Check at 55 sec

Mine stuck at number one ,,,,I want to find out if that indicate a problem or something else ?

Thx
 
Status
Not open for further replies.

Similar threads

James Nunnerley
  • Locked
  • Question
Long cable run causing issues
Replies
11
Views
411
SD Cabling
SD Cabling
skyzone
  • Locked
  • Question
Cable combs and sequential ordering
Replies
0
Views
242
skyzone
skyzone
Dexman
  • Locked
  • Helpful tip
A "Crappy" Installation. 1
Replies
7
Views
331
Dexman
Dexman
Steve432
  • Locked
  • Question
fluke dsp 4300
Replies
3
Views
403
libellis
libellis
IT Pro
  • Locked
  • Question
Structured Cable (Premise Wiring) Testing...
Replies
6
Views
323
Wanebo
Wanebo

Part and Inventory Search

Sponsor

Back
Top