I have an old Fluke 4300 cable analyzer that's been a work horse.
but in the last few weeks I will get - "Internal Fault Detected 111"
So I turned it off and on, and then it worked.
Now this week, it always brings up the "Fault".
The Fluke website says it's no longer supported.
Any of you experience this?
Is it time to replace it?
but in the last few weeks I will get - "Internal Fault Detected 111"
So I turned it off and on, and then it worked.
Now this week, it always brings up the "Fault".
The Fluke website says it's no longer supported.
Any of you experience this?
Is it time to replace it?