Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

floppy drive, mouse not working

Status
Not open for further replies.

billybee

MIS
Feb 14, 2002
12
US
Hello.
I'm trying to repair an old Packard Bell for my Uncle. It is running W95. When booting the mouse is detected, but doesn't show up when OS is loaded. In device manager the PS/2 mouse port shows a problem as does the sound card. I disabled the sound card but still no mouse. The computer was working until my Uncle tried to install a CD Rom drive from an old Sony Vaio.
I was going to boot to a startup disk and reformat the HDD and found that the floppy drive doesn't work. The floppy is detected but machine won't boot to it and when I try to read a floppy in Explorer, it says drive not accessible. Tried another cable and another floppy drive that I know works. The suspect floppy works in another computer. At this point I'm suspecting the floppy controller and the MB. Any ideas? Thanks.
Bill Burnette
 
I think that regrettably your suspicions might be correct... However, make sure you note any specific settings in the BIOS, and then try clearing CMOS - this may be a jumper, or if not, pull the battery for a few seconds. It's just possible CMOS is corrupted.

Good luck!


ROGER - GØAOZ.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top