Flexline flx680 configuration

[jblakeney]

I have a flx680 that appears to be set to "default" It has no configuration on it. When I run the initial configuration to set the IP address and such it then goes into a boot loop. It will run for about 1-2 minutes and restart.

If it helps here is the tail end of the log:
1236815043.836170+0+00043051+Drive+2+Drive set size is 3.
1236815043.836353+0+00043051+Drive+2+FsDriveIndex=1, lun=1 is this director drive
1236815043.836585+0+00043051+Drive+2+FsDriveIndex=2, lun=3 is this director drive
1236815043.836788+0+00043051+Drive+2+FsDriveIndex=3, lun=4 has not been assigned on other director !!
1236815043.836994+0+00043051+Drive+2+Returning 0 assigned drives.
1236815043.837160+0+00043051+Flow+2+Exiting: static OzDriveVector OzDriveManager::getAssignedOtherDrives()
1236815043.837396+0+00043051+Drive+2+OzDriveSetManager::restoreConfig() - no drive sets found.
1236815043.844201+0+00043051+Flow+2+Exiting: virtual void drive::OzDriveSetManager::restoreConfig()
1236815043.844566+0+00043051+Drive+1+OzDriveSetManager::initialize() ERROR - Caught drive exception No configuration found.
1236815043.861601+0+00043051+TLC+1+t:OzDriveModule::SystemStateMessageThread f:shutdown s:3 m:Environment issued terminate: possible uncaught exception
1236815043.862426+0+00043051+TLC+1+t:OzDriveModule::SystemStateMessageThread f:shutdown s:3 mumping Stack...
1236815043.863036+0+00043051+TLC+1+t:OzDriveModule::SystemStateMessageThread f:shutdown s:3 m:Backtrace for thread OzDriveModule::SystemStateMessageThread

Any help would be appreciated.