I am working on a Flash2 and would like to install the Flash4 expansion card. It is being used with a CICS 1.0. The problem is that it does not recognise the second two ports and when you phone the Flash local for the expansion it just goes to busy. I have gone into maintenance and disabled and enabled the port but it still does not work. Any suggestions?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Flash upgrade
- Thread starter ebcomm
- Start date
- Thread starter
- #3
- Thread starter
- #5
CICs was not seeing it in maintenance. I unplugged the port about 5 times before it finally decided to wake up. Not sure what was going on but in hindsight I should have probably powered down both the Flash and the CICs....maybe then it would have recognised the new ports.
Thanks for the reply.
Thanks for the reply.
- Status
Similar threads
