hi,
am programming a electron that simulates the process in a microwave-oven. The electron flies in a spiral around the kernal. When it reaches the outerdiameter it starts over again in the middle at the kernal. Now when the programm runs for about a minute the speed has significantly increased, without real cause. Does anyone know how to change this en let the programm run at one steady single speed?
tnx,
Mark Looman
LoomanMarkY@hotmail.com
am programming a electron that simulates the process in a microwave-oven. The electron flies in a spiral around the kernal. When it reaches the outerdiameter it starts over again in the middle at the kernal. Now when the programm runs for about a minute the speed has significantly increased, without real cause. Does anyone know how to change this en let the programm run at one steady single speed?
tnx,
Mark Looman
LoomanMarkY@hotmail.com