Flash Software upgrade

[byrontel]

What is the proper procedure to upgrade from version 1.7 to 2.0?
Will I lose all current programming in 4 portFlash by powering down,replacing software card,and powering up?
My Mics is an R1T1 software.
Thanks

 

[PhonesBrokeHuh]

This is what I have. Good Luck

To perform a StarTalk Flash software upgrade:

Open the module front door.

Remove the teladapt cord(s) from the teladapt line jack(s) inside the StarTalk Flash module. Important: This step must be completed to avoid any possible loss of configuration or programming information.

Wait one minute before proceeding to the next step.

Unplug the AC power to the StarTalk Flash module.

Remove the current PCMCIA ROM card.

Insert the new PCMCIA ROM card into the slot provided on the StarTalk Flash module.

Re-insert the teladapt cord(s) into the teladapt line jack(s) inside the StarTalk Flash module.

Plug the AC power back into the StarTalk Flash module.

 

[exsmogger]

When logging back into the Flash with the V2.0 card you will first use F903 to accept the feature code range F980-F989. Then dial F983 and you will get a Pswd: prompt. Enter 266344 and go through the configuration steps. When that finishes, dial F983, login, and you should find all your programming still intact.

Brian Cox

http://www.jandjcommunications.com