Firmware upgrade 1

[technical1]

Hi,
Ive just upgraded from version 6.0(1) to 6.3.3

This went successfully using tftp.
However after reboot, i get the following errors:

after installing 6.3.3
======================
..Sorry, not allowed to enter IP address on same network as interface 3
Config Error -- ip address intf4 127.0.0.1 255.255.255.255
Sorry, not allowed to enter IP address on same network as interface 3
Config Error -- ip address intf5 127.0.0.1 255.255.255.255
.ERROR: invalid ip address 0.0.0.0
Config Error -- failover ip address outside 0.0.0.0
ERROR: invalid ip address 0.0.0.0
Config Error -- failover ip address inside 0.0.0.0
ERROR: invalid ip address 0.0.0.0
Config Error -- failover ip address intf2 0.0.0.0
ERROR: invalid ip address 0.0.0.0
Config Error -- failover ip address intf3 0.0.0.0
ERROR: invalid ip address 0.0.0.0
Config Error -- failover ip address intf4 0.0.0.0
ERROR: invalid ip address 0.0.0.0
Config Error -- failover ip address intf5 0.0.0.0
.The sysopt route dnat option has been deprecated
Config Error -- no sysopt route dnat

Config Failed

Obviously its in the config, but whats soo different from version 6.0(1) and 6.3.3

Regards,
Vinay

 

[Lou0686]

Hi,

I just did the same and got the same errors. It's normal. You don't have failover configured. If you perform another reboot, you won't see that message.

Lou