I’m trying to build a simple action that resizes the open image, saves the resulting smaller image optimized as a specific filename (folder.jpg) in the same folder as the original, and then close the original without saving. The resize and the close steps are done. That’s the easy part. I also have the step built that uses the Save for Web command and it properly names the file to folder.jpg yet the step always wants to save the file into the directory that has been recorded. I would like that the file be saved into the same directory where it found the opened graphic even if I need to open each image individually and manually initiate the action. Is this possible?
As a matter of note, I have also tried to use Imageready and run into the same problem of file naming and saving along with the fact that I simply cannot automate the close image step.
Any help or guidance in this matter is greatly appreciated. I have nearly 3000 images on which to perform this operation.
As a matter of note, I have also tried to use Imageready and run into the same problem of file naming and saving along with the fact that I simply cannot automate the close image step.
Any help or guidance in this matter is greatly appreciated. I have nearly 3000 images on which to perform this operation.