Fiji007 and fiji010 0 0 0 errors

[dogg1]

Hi All,

Last couple of nights I have recieved these errors.

FIJI010 0 0 ALARM 00 - RECVS_FROM 00000001
%
% FIJI007
% NEW STATE RING 0: NONE
% RING 1: FULL
%
% FIJI010 0 0 ALARM 00 - RECVS_FROM 00000003
%
% FIJI007
% NEW STATE RING 0: HALF
% RING 1: HALF

I ran the "Test all" in LD 39 and all tests passed. I have reseated the two fiji's in ring 0(0 0 and 1 0) as was wells as cleaned the fiber jumpers. Not sure what I'm missing. Any suggestions?

 

[Firebird Scrambler]

I've found this report that might help

FIJI010 4 1 ALARM 00 - RECVS_FROM 00000010
FIJI010 3 1 ALARM 00 - RECVS_FROM 00000018
FIJI010 2 1 ALARM 00 - RECVS_FROM 0000001C
FIJI010 1 1 ALARM 00 - RECVS_FROM 0000001E

Above is alarms from a 4 group op81C
Take the first field.
FIJI010 4 1 this is (FIJI010) group 4 shelf 1 all of the alarms are for shelf 1
the final field is in hex and needs covering into Binary.
group no. 4 3 2 1 0
10 1 0 0 0 0 group 4
18 1 1 0 0 0 group 3
1c 1 1 1 0 0 group 2
1e 1 1 1 1 0 group 1


so group 4 can only see itself
group 3 can see group 3 and 4
group 2 can see group 2,3 and 4
group 1 can see groups 1,2,3 and 4

Ring 1 runs anti clockwise and no fiji can see the fiji in group 0.
another clue is no messages from FIJI in group 0.
so fiji card in group 0 shelf 1 is faulty (or cable from it to group 1)


Firebird Scrambler

Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer

Website =

http://somertel.myfreesites.net

linkedin

 

[KCFLHRC]

Is the current state ring 0 half and ring 1 half? That is how it should be. Could be a clocking issue also, check those connections or as stated something as simple as a bad Fiji card. Make sure the the clocks are showing an accurate status in ld 60 also. The Fiji cards connect to the clock controllers for timing.