Fiber Board Disconnect

[tkoon]

Is it safe to disconnect a fiber jumper going to an unused T-1 card on a MICS with 6.1 software. We no longer need the T-1 card at this location but need it at a different site?
If the card is removed at it's current location is there a board renumber similar to the Avaya Magix that needs to be done after the card is removed?

 

[Norstarguru]

If the card has no service, Go into maintenance and disable the card, then you can unplug it , it should not have a fiber cable plugged into it? It should be an RJ45.


norstarguru

http://www.1stalliancecom.com

 

[hawks]

You need to power down the system before removing the card.

 

[VencomRob]

The T1 card is in a fiber trunk module?
If it is in the main KSU, then no. You must power down.

If it's a 6.0 or higher MICS and the NT7N74AAAA is in a trunk module. Unplug the fiber and then power the trunk module down by pulling the plug. Then you can remove the card. If it's in a trunk module, no other cards were allowed in that TM so you can leave it off if you like.

 

[senk1s]

the fiber jumper is it going to the module? or the DTI card
because the card has a RJ45 input for the circuit