Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
FCT - nokia 22
- Thread starter tczmbara
- Start date
testcentre
Technical User
i assume you are using a Nokia Fixed Wireless Terminal connected to a trunk (Ring/Loop, TL11 or similar) on the MD110.
If this is so, then you should check the following:
1. Is the trunk looking for an Answer signal (polarity reversal) when the cellular call is connected - check in Route Category and Route Parameters (ROCAP & RODAP).
2. If the trunk route is set to look for an Answer, see if the FWT can provide this signal.
3. If the FWT cannot, then in Route Category and Route Parameters set the route for no Answer signal.
If this is so, then you should check the following:
1. Is the trunk looking for an Answer signal (polarity reversal) when the cellular call is connected - check in Route Category and Route Parameters (ROCAP & RODAP).
2. If the trunk route is set to look for an Answer, see if the FWT can provide this signal.
3. If the FWT cannot, then in Route Category and Route Parameters set the route for no Answer signal.
- Status