michaldsr
Technical User
- Jan 22, 2008
- 1
Hi everyone
I've obtained a clariion FC array FC5400 with 9 disks each 9 GB.
Recently i've bought 73 GB FC-AL disks.
The Array formated them but after the process status "uspupported disk" (in FLARE) has occured.
Ofcourse I wasn't able to bind new disks to a new raid.
My FC5400 has two THOR controllers with prom Rev: 4.26.
I've heard that upgrading THOR firmware may be helpful but
i have no idea where can i get an upgrade.
Disks 0_0, 0_1, 0_2 were on their places (not swaped or changed just old 9 G's).
New disks were placed as 0_7, 0_8, 0_9.
No active RAIDs were present.
Is there any way to run up those disks in this device?
thanks
mike
I've obtained a clariion FC array FC5400 with 9 disks each 9 GB.
Recently i've bought 73 GB FC-AL disks.
The Array formated them but after the process status "uspupported disk" (in FLARE) has occured.
Ofcourse I wasn't able to bind new disks to a new raid.
My FC5400 has two THOR controllers with prom Rev: 4.26.
I've heard that upgrading THOR firmware may be helpful but
i have no idea where can i get an upgrade.
Disks 0_0, 0_1, 0_2 were on their places (not swaped or changed just old 9 G's).
New disks were placed as 0_7, 0_8, 0_9.
No active RAIDs were present.
Is there any way to run up those disks in this device?
thanks
mike