Fatal Exception 0E at 0028:00012694 in VXD VMM(01)+ 00011694

[khamrick]

I am running WIN95B and have installed USB support along with a KW-580 PCI USB 2 port card. I ran the USBREADY.EXE program and it indicates my USB hardware/software are OK.

I installed an Artec Ultima 2000 USB scanner that is supposed to be supported by WIN95B.

After installing the scanner driver and starting the scanner I get the following error:

Fatal Exception 0E at 0028:00012694 in VXD VMM(01) + 00011694

The computer is locked up and the scanner LED is flashing. I never get the scanner software's menu displayed.

Any help would be appreciated.
Thanks,
Ken

 

[butchrecon]

Here are a couple of solutions. Hope they help.
"Fatal Exception 0D" Error Message Installing Program

ID: Q162390

The information in this article applies to:
Microsoft Windows 95

SYMPTOMS
When you are installing any program that uses the Windows Install wizard or the InstallShield installation program, you may receive the following error message:

A Fatal Exception Error 0D has occurred in VxD VMM(01) + 00001840

CAUSE
This error message can occur if you have Stacker version 4.1 installed on your computer.

RESOLUTION
To resolve this issue, use either of the following methods:
Contact Stac Electronics for a possible fix.
Disable 32-bit disk access for all drives. To do this, follow these steps:
Click Start, point to Setting, and then click Control Panel.
Double-click System.
On the Performance tab, click File System.
On the Troubleshooting tab, click the "Disable all 32-bit protect- mode drivers" check box to select it.
Click OK, and then click Close.
Click Yes when you are prompted to restart your computer.

"Fatal Exception 0E" Error Message When Running McAfee VirusScan
ID: Q177672

The information in this article applies to:

Microsoft Windows 95
Microsoft Windows 95 OEM Service Release version 2

SYMPTOMS
When McAfee VirusScan95 with VShield scanning software detects a virus on your computer, you may receive the following error message:

A fatal exception 0E has occurred at 0028:C0003C72 in VXD VMM(01) + 00002C72. The current application will be terminated.
NOTE: In addition to this error message, your computer may stop responding (hang) or restart when a virus is detected.

CAUSE
This behavior can occur if your video adapter uses the Tseng Labs ET6000 chip set.

RESOLUTION
Upgrade to Release 6, version 4.03.4800 or later of the Tseng Labs ET6000 video adapter driver for Windows 95. To obtain this driver, contact Tseng Labs.
James Collins
Computer Hardware Engineer
A+, MCP

email: butchrecon@skyenet.net