I have a 0x32 MICS DR 4.1 S/W and a FastRad. I also have NRU 9.0. I can not complete a backup of my system. It inializes the Rad which is set at 19200, it accepts the password, and looks as if it is going to start backing up the software (small Flashing folder and KSU) on a screen) but then a message pops on that says internal error #81. Has anyone seen this before. I manage 65 different systems from 6x16 to MICS 5.0 and started backing them all up, and have ran into trouble when I started on this level, 4.1 sofware.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
FastRad and backup problems
- Thread starter Qwiksting
- Start date
Qwiksting,
Sounds as if the 81 error is a windows based notice? How convenient is it to swap out the Fastrad for another removing the issue that it is bad? If not the rad, I have had some poor connections forcing me to dial in a couple of times to get in.
???? Let us know. Perhaps tommorrow during working hours someone will have an idea.
Cheers
PhM
Sounds as if the 81 error is a windows based notice? How convenient is it to swap out the Fastrad for another removing the issue that it is bad? If not the rad, I have had some poor connections forcing me to dial in a couple of times to get in.
???? Let us know. Perhaps tommorrow during working hours someone will have an idea.
Cheers
PhM
- Thread starter
- #3
Well I am doing a direct connect with the system..9 pin cable from laptop to FastRad...and I thought about that last nite.. I have another rad to swap out, it just seems funny though. And the way the error #81 comes up..it seems that it is from the NRU software, but I am gonna give it a go today. Thanks
- Status
Similar threads
- Locked
- Question