I have 2 x1232TD PABXs which are installed at 2 different locations but are linked by extensions appearing as exchange lines on the other and viceversa to enable transfer and cheaper communication.The problem is that when a call is transferred to the other PABX it fails to disconnect after hanging up and this is causing unnecessary congestion on the "tie lines".
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Failure to disconnect
- Thread starter mbonjani
- Start date
rivet
Programmer
- Mar 20, 2005
- 336
thats right''' the trunk line does not provide the signal to tell the line to hang up thus the line stay's open
its called cpc signal detect
if you read back a few posts you will see this posted also has all the info on what equipment you need and a link to where to get it
hope this helps
its called cpc signal detect
if you read back a few posts you will see this posted also has all the info on what equipment you need and a link to where to get it
hope this helps
rivet
Programmer
- Mar 20, 2005
- 336
- Status