Failed to receive data

[Stephan0408]

Hello,

since a few days i have the following problem. I created a job for 10 NT4-server in arcserveit 6.61 SP2. There are two servers, which are not backuped. One time Server No. 4 "failed to receive data" the other day Server No. 8. Both server have the nt-agent installed. If i install the nt-agent on both servers again the job is running on one of server but not on the other because of failure "EC=10065".
I have allready set the NIC of the backup-server and the clients to halfduplex.
Has anyone an idea ?

Stephan

 

[TheLad]

The following link may be helpful (even if the TID is a bit confusing). Basically it says to create a HOSTS (and maybe even an LMHOSTS.SAM) file containing your servers IP addresses.

In NT, the HOSTS and LMHOSTS.SAM files are in C:\WINNT\SYSTEM32\DRIVERS\ETC

http://support.ca.com/techbases/rp/RP0012.html

-----------------------------------------------------
"It's true, its damn true!"
-----------------------------------------------------

 

[Stephan0408]

Sorry of my bad English.

I set the Agents to use specific IP adresses and password security. We are using DNS and no HOSTS or LMHOSTS.
The peculiar is, that once the one is backuped then the other day the other.