External paging with Bogen Amp

[hm1]

I have an MICS 7.0 and trying to connect the external paging but it won't work. I can test the Bogen paging with my but set and the MICS page port. They will not work together. I tried using an avail C.O. port with the same outcome. Any ideas?

 

[PERRYPJ]

Do you hear anything coming out of the MICS on the external page pair, if so what kind of Bogen are you usinf

OLD ROLMEN WORKING ON NORTELS AND AVAYA

 

[hm1]

Sometimes you can hear the speakers give the alert tone and very very low volume. We are using the Black /Slate page pair from MICS. The page controller is a ZPM 3

 

[exsmogger]

Amps usually have either several different inputs, or a switch to change between inputs. When using the paging pair you would normally use the 600 ohm input. When using a CO you would use the dry input. Some amplifiers also need to use the contact closure pair. This would be the yellow-blue pair just below the paging audio pair.

Brian Cox
BC Telecom Services

 

[PERRYPJ]

The Bogen ZPM3 is a telephone-compatible zone paging module
with all-call and talk back capabilities serving up to three
one- or two-way paging zones.The ZPM3 can also be used in
a paging system independent of a telephone system.

Your going to have to operate this off a Trunk Port for it to work correctly

OLD ROLMEN WORKING ON NORTELS AND AVAYA

 

[curlycord]

What happens if going from MICS page port to Tel input, in otherwords without the ZPM?

Also test page holding your probe up to the port.

=----(((((((((()----=
curlycord

http://www.curlycord.com

 

[hm1]

If i am using a trunk port I need some sort of additional voltage, Correct?