Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
External Paging in BCM 450
- Thread starter mrtech00
- Start date
As long as you allow the set to page and are directing the page to external there is nothing special you need to do on the 450.
That being said, I've had 2 systems where the page jacks were defective. Since they were brand new, Nortel replaced the BFTs.
If it's out of waranty and you're good with a soldering iron, you could replace the jack yourself but it sure looks like a pain in butt to do it.
That being said, I've had 2 systems where the page jacks were defective. Since they were brand new, Nortel replaced the BFTs.
If it's out of waranty and you're good with a soldering iron, you could replace the jack yourself but it sure looks like a pain in butt to do it.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
